Teach You How To Quickly Find Out Why The Tattoo Machine Stops Working

If your machine suddenly stops working, first check whether it is the machine or the power supply. Switch to another machine and start it up to see if it works. If another machine can work, it means that the original machine has failed. You don't need to repair it immediately. You can change another machine to continue your tattoo creation. It is definitely not a wise choice to stop tattooing operation and repair the machine, which will make customers dissatisfied and doubt your ability.

If the newly replaced machine cannot be started at all, it may be a short circuit or an open circuit. The first line is to check whether your contact point is clean. If something catches between them, it will damage the circuit.

The moving coil is another place that should not be ignored. If the machine doesn't work at all, or the power of the machine is very weak, it may be the cause of your machine's coil. If the coil is broken, you can take out the two screws at the bottom of the rack first, and then replace them. Pay attention to the original position of the bolt washer under the coil. Replace with a new coil and reconnect the wires on the new coil. If your machine has a capacitor, it needs to be replaced at the same time.

If the machine stops immediately after starting, or does not work at all, check whether there is a loose screw or a short circuit in the wire. The tattoo machine is quite simple and can be easily calibrated. As the machine vibrates frequently during operation, many parts are easy to loosen. Readjusting or tightening the screws at various parts may restore normal operation. The key lies in daily maintenance.