Precautions after use of tattoo machine

The tattoo machine converts the externally connected 220V exchange power into a DC power with a voltage value between 3-20v through a voltage regulator and a transformer. Under a DC voltage of 3-20v, the two main coils and the electronic injection point generate an instantaneous suction and injection effect. With the help of the reciprocating motion of the spring plate of the tattoo machine, the tattoo needle is driven to generate high-speed high-low and reciprocating motion One of the greatest advantages of this working method is that it is not driven by the motor, and it does not need to consider the power consumption of the motor, so it may produce high rotation speed and large torque. When working, the tattoo needle punctures the epidermal layer at a high speed and evenly, and the tattoo pigment is implanted into the basal layer of the epidermal layer, so that the pigment is permanently fixed in the epidermis, forming beautiful patterns and words of various pigment combinations, which can embellish the skin and cover the epidermal scars

(1) The rubber band should be removed so as not to relax

(2) The medical steel handle should be removed and cleaned with clean water - - soaked in disinfectant - - rinsed with clean water - - sealed with a disinfection tube bag - - disinfected with a high-temperature and high-pressure disinfection pot; The disposable handle shall be removed and discarded

(3) Turn off the transformer

(4) Check whether the tattoo needle tail pad and damping ring are worn and replace them with new ones

Needle mounting method

(1) Split needle: install the needle bar on the armature, fix the needle bar with your right hand, install the needle on the needle bar after installing the handle with your left hand, then install the needle mouth, press the armature with your hand, adjust the length of the needle and fix it

(2) Conjoined needle: install the conjoined needle on the armature, fix the needle with your right hand, install the handle with your left hand, then install the needle mouth, press the armature with your hand, adjust the length of the needle, and fix it