Causes And Solutions Of Tattoo Machine Not Working

1. The elastic rod does not touch the contact of the inclined spring, loosen the screw of the elastic rod, rotate the elastic rod downward to touch the contact, and then rotate it to the appropriate position, tighten the screw to lock the elastic rod

2. The power switch is not on. Turn on the power and turn on the power switch. The indicator light is red

3. The adjusting button is at the zero position, and the V meter pointer is also at the zero position. The adjusting button rotates slowly clockwise, and the V meter pointer is also rotating. The V meter pointer should stop at 6-10v.

4. When the elastic rod touches the front elastic contact, it is too tight to start, which is more likely to cause a short circuit of the power supply. Turn on the power switch, and the indicator light will be green without voltage. Loosen the screw of the elastic rod, loosen the elastic rod upward from the elastic contact, readjust the elastic rod to touch the contact, restart the power supply, and adjust the elastic rod to the appropriate position.

5. Shutdown during work: it is often not clear when you pull the power cord carelessly and leave the joint position during work.

Check whether the plug of the foot switch and the power line is in place

6. When cleaning and disinfecting the tattoo machine after work, pull the wire on the machine (dislocation), check whether the wire head on the tattoo machine is dislocated (broken), and ask an electrician to weld the wire

7. Turn on the power and the indicator light will jump to green. Check whether the plug on the power line and the plug on the foot switch are broken. If it is broken, it may touch the wire (short break). If it is broken, solder it with a soldering iron, and then it is OK!